Loading... Please wait...

Our Newsletter


88-97 GM 36.5 Spring Center Solid Axle Conversion Hanger Kit

  • Image 1
  • Image 2
Price:
$395.00
SKU:
CHEVY-SAS-002
Weight:
60.00 LBS
Shipping:
$54.95 (Fixed shipping cost)
Quantity:
Bookmark and Share


Product Description

Estimated lead time is 1-2 weeks.

This is a kit that will add 6" of lift over your spring size, so 12" springs nets 18" lift. Current kit can be positioned to almost any height up to 6 inch by moving rear shackle hangers up the frame and re drilling front spring eye. 3/4 and 1 ton frames will require minor trimming of front hanger due to frame cross member that is not removable like a 1/2 ton. Below are a few shots of the process. Also check the picture section for more info on installation.

Uses Chevy 4x4 lift 73-87 era 47" front springs. Hangers can be pushed forward and back to stretch spring length needed to run 52 inch rear springs. You will need to fabricate 4 3/8ths spacers for the front leaf hanger to run the narrower springs. Kit is bolt on for positioning is desired, final install will require full welding. Exhaust modifications may be needed. 

The 36.5" width spring perch kit ( SAS-002 ) will only fit the 39.5 Chevy frame. The kit will fit Ford axles with a spring pad width of 36.5".

General Install length with a lift and proper tools cutting no corners is 35-40 hours. This is not re gearing the axles or and fine tuning or rear lift options

Note: A good starting point for spring hanger eye to eye measurements is 46". This is a minimum length.

This kit will allow the use of a 86-97 Ford Dana 60 high pinion front axle. Kit will work with either a king pin or ball joint style axle. We have steering kit options available for both axles. This kit will only work with 2.5 wide after market springs with a 3.625 bushing width, no stockers, as you will need to machine down the rear spring bushings to a 3 inch over all width, and use our provided spacer in the shackle to get the correct 36.5 spring center. Upper shackle hanger bolt on the rear shackle hanger will need to be test fit and cut down as needed to fit hanger to frame tolerance. 
Kit is not available in separate parts at this time due to limited production quantities.

Kit is still a 6" plus spring lift... For example: If you have 6" springs, and our kit, you will net 12" of lift.
This will vary slightly with huge winch bumpers/winch combos, big block all steel engines, and exo-cages.

**Please refer to the diagram/picture above on where to properly measure the INSIDE of your frame. 

Find Similar Products by Category

Write your own product review

Product Reviews

This product hasn't received any reviews yet. Be the first to review this product!

Add to Wish List

Click the button below to add the 88-97 GM 36.5 Spring Center Solid Axle Conversion Hanger Kit to your wish list.

You Recently Viewed...